Insta360 CINSABQA FALO 2 Axis Gimbal

Flow 2 Introduction

1. Telefoni maneta Clamp
2. Faʻamoe Axis Motor
3. Fa'atonuga fa'amaneta
4. Malosiaga Output Port
5. Battery Level/Gimbal Mode Indicator Lights(Type-C) 4.
6. Fa'amau Fa'amau
7.  Pan Axis Motor
8. Power Button (M Button)
9. La'au Selfie Fausia
10. 1/4″ Fa'amauina
11. Ki fa'aoso
12. Faasipa afi au
13. built-In Tripod
14. C Faamau
15. Suiga ki
16. Joystick
17. Malosiaga Ulufale (ituaiga-C)
18.  Uili Sao

Totogiina

Use the included Type-C Cable to connect the “IN” Port on the handle to the charger.The battery level indicator lights will change during charging according to theremaining power level. All four indicator lights turning solid means charging iscomplete.Flow 2 features two Type-C ports. The “IN” Port on the handle is the charging port,which is used to charge the gimbal. The “OUT” Port located on the arm is the poweroutput port. To use Flow 2 as a power b ank while it is off, connect your phone to the”OUT” port and press the Power/M Button once to begin charging.

Flow 2 Charging Time

• 0-80% in 55 minutes
• 0-100% in 120 minutes
• measured at 77°F (25°C) using a 10W charger.

Fa'amauina se Telefoni

Attach the Phone to the Magnetic Clamp

• Extend the Magnetic Phone Clamp around the middle of your phone, following the icon on the clamp’s right side.
• Ensure the phone’s camera faces the direction marked on the Magnetic Phone Clamp.

Fa'apipi'i le Clamp to the Gimbal

• Align the magnetic notch on the back of the clamp with the raised bump on the gimbal’s magnetic surface.
• Match the magnetic groove on the clamp with the red dot (Magnetic Alignment) on the gimbal. Securely attach the clamp.

Unfold and Power On

• Hold the handle with one hand and pull the arm outward with the other to unfold the gimbal.
• The gimbal powers on automatically. Wait for the indicator light to activate, signalling it’s ready for use.

Fa'amatalaga

• When pulling out the tripod, pull out all legs together, not individually.
• When storing the tripod, fold the legs first, then slowly push them back in with the palm of your hand.
• If you have the selfie stick extended for a long time, it’s recommended to attach an external tripod through the 1/4″ screw hole at the bottom of Flow 2’s handle for more support and use in a wider range of scenarios.

Folding and Powering Off

1. Long-press the Power Button to power off Flow 2.
2. After powering off, hold the phone securely and fold the gimbal arm down to its storage position.
3. Detach the phone and the Magnetic Phone Clamp.

Pepa / Punaoa

Insta360 CINSABQA FALO 2 Axis Gimbal [pdf] Faatonuga CINSABQA, CINSABQA FLOW 2 Axis Gimbal, Flow 2 Axis Gimbal, Axis Gimbal, Gimbal

Fa'asinomaga

• Tusi Taiala