SAMSON SWAS5LM5

Samson LM5 Lavalier Microphone Instruction Manual

Model: SWAS5LM5

1. Folasaga

The Samson LM5 is a compact, omnidirectional lavalier microphone designed for clear voice reproduction in various applications. It features a 3.5mm miniplug connector, specifically engineered for seamless integration with Samson wireless beltpack transmitters. This manual provides essential information for the proper setup, operation, and maintenance of your LM5 microphone, ensuring optimal performance and longevity.

Vaega e aofia ai:

  • LM5 Lavalier Microphone
  • Fulu matamata matala
  • Kipi faaleotelefoni

2. Seti

2.1 Attaching the Microphone Clip

Secure the included microphone clip to the body of the LM5 lavalier microphone. The clip allows for easy attachment to clothing, such as a lapel or tie, ensuring stable positioning during use.

2.2 Installing the Foam Windscreen

Gently slide the foam windscreen over the microphone capsule. The windscreen helps to reduce plosive sounds (P-popping) and wind noise, improving overall audio clarity.

2.3 Connecting to a Transmitter

The LM5 microphone is designed for use NA'O with Samson wireless beltpack transmitters. Insert the 3.5mm miniplug connector firmly into the microphone input jack on your Samson wireless beltpack transmitter. Ensure the connection is secure to prevent signal loss.

Samson LM5 Lavalier Microphone with 3.5mm Miniplug Connector and foam windscreen

Image: The Samson LM5 Lavalier Microphone, shown with its 3.5mm miniplug connector and an attached foam windscreen. This image illustrates the microphone's compact design and its primary components.

3. Fa'atonuga o Galuega

3.1 Tu'u le masini faaleotele leo

For optimal sound quality, position the LM5 microphone approximately 6-8 inches (15-20 cm) from the speaker's mouth. Attach it to clothing in a location that minimizes rubbing or contact with other objects, which can cause unwanted noise.

3.2 Malosiaga

Once connected to your Samson wireless beltpack transmitter, refer to your transmitter's manual for instructions on powering it on and establishing a wireless connection with its receiver.

3.3 Fetuuna'iga o Tulaga

Adjust the input gain on your Samson wireless beltpack transmitter and the corresponding receiver to achieve appropriate audio levels. Monitor the audio output to prevent clipping or distortion.

4. Tausiga

4.1 Fa'amamāina

To clean the microphone, gently wipe the exterior with a soft, dry cloth. Do not use liquid cleaners or solvents. The foam windscreen can be carefully removed and cleaned with mild soap and water, then allowed to air dry completely before reattaching.

4.2 Teuina

When not in use, store the LM5 microphone in a clean, dry place, away from extreme temperatures and humidity. Avoid tightly coiling the cable to prevent damage.

4.3 Tausiga o Uaea

Handle the microphone cable with care. Avoid sharp bends, kinks, or excessive pulling, which can damage the internal wiring and connector.

5. Faʻafitauli

5.1 Leai se leo e maua mai ai

  • Siaki So'oga: Ensure the 3.5mm miniplug is fully inserted into the Samson wireless beltpack transmitter.
  • Malosiaga fa'asalalau: Verify that the wireless beltpack transmitter is powered on and functioning correctly.
  • So'oga Receiver: Confirm the wireless receiver is properly connected and receiving a signal from the transmitter.
  • Fegalegaleai: Remember the LM5 is designed for Samson wireless beltpack transmitters only.

5.2 Poor Sound Quality / Excessive Noise

  • Tu'u le masini faaleotele leo: Adjust the microphone's position to be closer to the sound source and away from clothing or jewelry that might cause rubbing noise.
  • Matamata: Ensure the foam windscreen is properly installed to reduce plosives and wind noise. Replace if damaged.
  • Tulaga maua: Check and adjust the gain settings on your transmitter and receiver to avoid distortion or low signal.
  • Fa'alavelave: If using a wireless system, check for potential wireless interference and adjust channels if necessary (refer to your wireless system's manual).

5.3 Clip Issues

If the microphone clip becomes loose or breaks, it may need to be replaced. Contact Samson support for replacement parts.

6. Fa'amatalaga

Fa'aaligaFa'amatalaga
Fa'ailogaSAMSON
Igoa Fa'ata'ita'igaSWAS5LM5
Tekinolosi Feso'ota'iWireless (via compatible transmitter)
Ituaiga Feso'ota'i3.5 mm Miniplug
Fa'apitoa Fa'apitoaUa aofia ai le kilipa
Masini FegalegaleaiSamson Wireless Beltpack Transmitters
LanuLanu uliuli
Mamanu PolarOmnidirectional
Fa'ailoga Fa'aaufa'atasiLavalier (microphone only)
Punavai MalosiCorded Electric (via transmitter)
Fua Faatatau o Faailo-i-Pisa78 dB
Mea Fa'amauApa siliva
Mea mamafa24.77 g
Ituaiga Mea51.57 x 0.2 x 0.2 inisi
TufugaSamson Technologies

7. Fa'amaonia ma Lagolago

7.1 Fa'amatalaga Fa'amaonia

The Samson LM5 Lavalier Microphone is covered by a 1-tausaga vaega ma galuega fa'amaonia mai le aso na fa'atau ai. O lenei tusi saisai e aofia ai fa'aletonu i meafaitino ma galuega i lalo ole fa'aoga masani. Fa'amolemole taofi lau fa'amaoniga o le fa'atau mo tagi fa'amaonia.

7.2 Fesoasoani mo Tagata Fa'atau

For technical assistance, troubleshooting, or warranty service, please visit the official Samson Technologies website or contact their customer support department. Contact information can typically be found on the Samson website or in the documentation provided with your wireless beltpack transmitter.

© 2024 Samson Technologies. Taofia aia tatau uma.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.